Backlight - Harman Martin RUSH MH 10 Beam FX User Manual

To set the fixture's dimmer curve:
1. Select DIMMER CURVE and press ENTER to confirm. The mode that is
currently active will blink in the display.
2. Use the DOWN and UP buttons to select the desired mode.
3. Press ENTER to save your selection.
Dimming curve can also be set by DMX using the Special Function channel.
Dimmer speed
There are two dimmer speed options:
•
SNAP is the default setting. It sets the dimmer to exactly follow changes in
dimming level sent from the controller. This gives the fastest dimmer
response.
•
FADE adds an approximate two-second smooth fade to changes in
dimming level sent from the controller. This gives the smoothest dimmer
fading.
To set the dimmer speed:
1. Select DIMMER SPEED and press ENTER to confirm.
2. Use the DOWN and UP buttons to select SNAP or FADE. Press ENTER
to confirm.

Backlight

To turn the control panel display backlight on or off:
1. Select BACK LIGHT and press ENTER to confirm. The current mode will
blink in the display.
2. Use the DOWN and UP buttons to select ON or OFF.
3. Press ENTER to save your selection.
The backlight can also be turned on or off by DMX using the Special Function
channel.
22 RUSH™ MH10 Beam FX User Manual