Table of Contents
Advertisement
1. Select SHOW MODE and press ENTER to confirm. The currently selected
show will blink in the display.
2. Use the DOWN and UP buttons to select Show 1, 2, 3 or 4.
3. Press ENTER to save your selection.
Master/slave operation
Fixtures in Show Mode can be linked in a chain and set to master/slave
operation, where one master fixture running a standalone show controls the
behavior of slave fixtures. Two slave modes are available:
•
Fixtures in Slave 1 mode copy the master.
•
Fixtures in Slave 2 mode are synchronized with the master but have slight
variations in behavior.
You must set all the fixtures except one as slaves. If you set more than one
fixture in the chain to act as master, you may cause damage that is not
covered by the product warranty.
To operate fixtures in master/slave mode:
1. Link fixtures in a chain, using DMX cable to connect one fixture's DMX
OUT socket to the next fixture's DMX IN socket. See 'Control data link' on
page 16.
2. In the MASTER SLAVE menu, set one fixture to MASTER and set all the
other fixtures to SLAVE 1 or SLAVE 2.
3. Set the master fixture in the chain to run one of its four standalone shows
using its SHOW MODE menu (see 'Show Mode' above).
4. Set all the fixtures in the chain to DMX STATE SHOW MODE.
5. Make sure that the fixtures are not receiving a DMX signal.
Sound activation in show mode
Show Mode can be combined with sound activation. The fixture has a built-in
microphone that can be used to trigger scene changes in sync with a music
beat (music trig) when the fixture is running in Show Mode.
To enable sound activation:
1. Select SOUND MODE and press ENTER.
2. Use the DOWN and UP buttons to select ON (sound activation enabled) or
OFF (sound activation disabled).
3. Press ENTER to save your selection.
To adjust the sensitivity of sound activation to the volume of the music:
1. Turn on the music source and set it to the desired volume.
2. Select SOUND SENSE and press ENTER.
20
RUSH™ MH10 Beam FX User Manual
Advertisement
Table of Contents
