Table of Contents
Advertisement
To split the link into branches, use an opto-isolated splitter such as the
Martin® DMX 5.3 Splitter. Terminate the link by installing a termination plug in
the output socket of the last fixture. The termination plug, which is a male XLR
plug with a 120 Ohm, 0.25 W resistor soldered between pins 2 and 3, "soaks
up" the control signal so it does not reflect and cause interference. If a splitter
is used, terminate each branch of the link.
Connecting the data link
To connect the fixture to data:
1. Connect the DMX data output from the controller to the closest fixture's
male XLR DMX input connector.
2. Connect the first fixture's DMX output to the DMX input of the next fixture
and continue connecting fixtures output to input. Terminate the last fixture
on the link with a DMX termination plug.
RUSH™ MH10 Beam FX User Manual
17
Advertisement
Table of Contents
