Led Temperature; Fixture Time; Firmware Version; Pro Defaults - Harman Martin RUSH MH 10 Beam FX User Manual

Table of Contents

2. Press the ENTER button. The fixture will run a self-test routine.

LED Temperature

To check the LED Temperature of the fixture, select LED TEMP. and press

ENTER. The display will show the temperature of the unit. Press MENU to

exit.

To display the fixture's operating hours counter, select FIXTURE TIME and

press ENTER. The display will show the number of hours the fixture has been

in operation since manufacture. Press MENU to exit.

To display the fixture's current firmware version, select FIRMWARE VERSION

and press ENTER. The display will show the version of firmware in the fixture.

Press MENU to exit.

PRO Defaults lets you cancel any changes in fixture settings that have been

made using the control panel and return the fixture to its original factory default

settings. To restore the default settings:

1. Select PRO DEFAULTS and press ENTER. The display will blink.

2. Use the DOWN and UP buttons to select YES.

3. Press ENTER to restore the default settings (or press MENU to exit

without making any changes).

The fixture resets its motors each time you power it on, but you can also reset

the fixture motors manually from the control panel and by DMX. To carry out a

manual reset from the control panel, scroll to RESET and press ENTER to

reset the fixture, or press MENU to exit without resetting. A reset takes approx.

20 seconds. After this, the fixture returns to its state before the reset.

The fixture motors can also be reset by DMX using the Special Function

channel.

Fan speed can be adjusted to maximize light output or quiet operation.

1. Select FAN MODE and press ENTER.

2. Using the DOWN and UP buttons, toggle between the two modes:

RUSH™ MH10 Beam FX User Manual

Table of Contents