Table of Contents
Advertisement
Before calibration is attempted, the system should be allowed to reach set temperature and
Hello Message
The Hello Message feature of the MBT 350 allows the operator to enter a message that will be
displayed when the system is turned on. To access the Hello Message menu, press and hold the
PROGRAM Key and DOWN
Version" appears. The MBT 350 will display " Do you want to input a Hello Message? Using the UP
key, scroll through the characters pausing on your selection. Press the
move the cursor to the next character. Press the setup key twice to exit the Hello Message menu.
If a hello message has been entered, the display will prompt the user to delete the hello message.
Press the UP
key to change the hello message or press the DOWN
the normal operation mode.
Corrective Maintenance
Power Source
Refer to the table below. Most malfunctions are simple and easy to correct.
Symptom
No power to system
Heater Assembly does not
heat
Little or no air flow, heater
heats and blower is running
Little or no vacuum
Vacuum Cup will not hold
component
Vacuum Pickup Rod binding
©2005 PACE Inc., Annapolis Junction, Maryland All Rights Reserved
NOTE
stabilize for at least 15 seconds before calibrating.
arrow keys while powering on unit. Release keys when "Software
Probable Cause
Blown Fuse
Line cord unplugged
Open Heater
Kinked air hose
Worn vacuum pump
Worn or broken
vacuum cup
Vacuum Pickup rod is
bent
Solution
Inspect and replace the fuse(s) located on the power source
rear panel
Plug line cord into the appropriate AC outlet
Contact PACE for assistance
Change routing of air hose to remove
kinks
Replace vacuum pump. Contact PACE for assistance.
Replace vacuum cup
Contact PACE for assistance
PROGRAM Key once to
arrow key to exit and return
Page 16 of 19
Advertisement
Table of Contents
