Table of Contents
Advertisement
9. The LED Display now reads "End". The Set-Up Mode procedure is now complete.
Choose one of the following steps:
Press and release the Scroll Up Key ( ) to save the changes, exit the Set-Up
•
Menu and return to normal operation.
Press and release the Scroll Down Key ( ) to return to the start of the Set-Up
•
Menu without saving any changes. Go back to step 3, Password Entry.
Corrective Maintenance
Display Message Codes
Display
Message
The incorrect password has been entered. The displayed message will time
"no"
out after 6 seconds and revert to normal operation. Enter the correct
password.
"Over Current Error" The Heater circuit is shorted, or the handpiece has
"OCE"
failed. Inspect handpiece and heater element, replace as needed.
"Open Sensor Error" Unit is unable to sense the sensor from the handpiece.
"OSE"
Make sure handpiece is connected. Inspect handpiece and heater element
for damage or wear, replace as needed.
The AutoOff feature has activated, turning off the handpieces. Press any
"OFF"
button on the unit to return to normal operation.
Power Source Issues
Most malfunctions are simple and easy to correct.
Symptom
No power to
system
Handpiece not
heating up
Spare Parts
Description
Fuse 1 Amp, Time Lag (for 115V)
Fuse 0.50 Amp, Time Lag (for 230V)
Optional under shelf mounting bracket
Service
Please contact PACE or your local distributor for service and repair.
©2022 PACE Inc., Vass, North Carolina, All Rights Reserved
https://paceworldwide.com/
Probable Cause
Blown Fuse
Defective Heater Element
Power Source Malfunction
Description
Solution
Replace the fuse (located in the AC
Receptacle Fuse Holder) with one of the
same.
Refer to the appropriate handpiece
manual.
Contact PACE
PACE Part Number
1159-0246-P5
1159-0213-P5
1321-0609-P1
Page 8
Advertisement
Table of Contents
