Pace 5050-0552 Operation And Maintenance Manual page 10

4. Inspect all system components, check for shipping damage, and ensure that all
purchased components (standard and options) are present. Use the drawings provided
in the following pages as a guide for checking the parts that come with the unit.
5. Assemble Tip & Tool Stands. Attach to the power source if desired. Assembly
instructions are enclosed with each Tip & Tool Stand.
6. Connect blue handpiece connector plug(s) to
the blue power receptacle(s) CH 1, CH 2
and/or CH 3 in the following manner. See Fig.
3a.
a) With the Connector Key end facing the
power source, turn the Locking Ring fully
counterclockwise.
b) Orient guide on connector with slot of
power receptacle.
c) Insert connector into power receptacle.
d) Turn Locking Ring fully clockwise to lock
in place.
7. To avoid confusion among handpieces, PACE
recommends the use of colored cable markers
(P/N 6993-0136 Cable Marker Kit) to identify
the particular handpiece. Attach any two like
colored markers, one to each end of the
handpiece power cable or air hose. Select and
use a different colored marker for each
handpiece. Labels are also provided to mark
Tip & Tool Stands with the name of the
associated handpiece.
8. If you have purchased an optional foot pedal,
insert the connector plug into the PEDAL
Receptacle on the rear panel of the power
source. See Fig. 3b. Install additional
handpieces and accessories as necessary.
9. Plug the prong end of the power cord into a
convenient three wire grounded AC power
outlet. The system is now ready for operation.
10. Read the "OPERATION" section of this manual thoroughly before operating the system.
©2005 PACE Inc., Annapolis Junction, Maryland All Rights Reserved
Figure 3a
Figure 3b
Page 10 of 19