Table of Contents
Advertisement
8. Set LCD Contrast
Press the UP
and DOWN
1 to 100. Press and release the PROGRAM Key
9. Set LED Backlite
Press the UP
and DOWN
1 to 100. Press and release the PROGRAM Key
7. Exiting the Programming Menu
The LED Display now reads "End". The Set-Up Mode procedure is now complete. Choose one of the
following steps:
a) Press and release the UP
b) Press and release the DOWN
Temperature Adjust Mode
To increase of decrease handpiece temperature, press the UP
display will show the current temperature setting for channel "1". Press the UP
keys to increase of decrease handpiece temperature for channel "1". Or press the
to move the next channel. After a period of 10 seconds of inactivity, the display will return to normal
operation.
Setting Channel Offset
To increase of decrease handpiece temperature offset, press the
will show the current temperature offset setting for channel "1". Press the UP
to increase of decrease offset temperature for channel "1". Or press the
next channel. After a period of 10 seconds of inactivity, the display will return to normal operation.
Accessing Calibration Menu
Press and hold the
when "Software Version" appears. Follow the instructional prompts to review or set each menu
option.
Calibration Instructions
The steps for the procedure are:
1. Remove any offset from the system by disconnecting the handpiece from the system. Re-
connecting the handpiece and proceed to step 2.
2. LED should go to amber. Set the MBT 350°F to (700°C).
3. Record the actual temperature of the tip from your temperature verification device.
4. Place the MBT 350 into the Calibration mode. Start with the system power switch in the off
position. Press and hold the
system on. Release both keys when the display reads version 1.2 or higher.
5. The display will now read Channel "1" System Cal? Press the
for channel "1". Press
6. Use the UP
verification device. For example, your temperature verification device reads 695 °F. Scroll through
until the display reads 695.
7. Press the
PROGRAM Key to save calibration and move to the next channel. Upon exiting,
LED will illuminate green and the display will return to normal operation mode.
©2005 PACE Inc., Annapolis Junction, Maryland All Rights Reserved
to enter increase or decrease LCD contrast. The range of contrast is
to enter increase or decrease LCD contrast. The range of backlite is
Key to exit Set-Up Mode and return to normal operation.
Key to return to the start of the Set-Up Mode procedure.
PROGRAM Key and the
PROGRAM Key and the
key / NO to move to the next channel.
and DOWN
keys to enter the temperature that you recorded by the temperature
to move to the next step.
to move to the next step.
or DOWN
PROGRAM Key once. The display
PROGRAM Key to move the
UP keys while powering on unit. Release keys
UP key while turning the
UP key to enter a temperature
arrow key once. The
or DOWN
arrow
PROGRAM Key
or DOWN
arrow keys
Page 15 of 19
Advertisement
Table of Contents
