Spectra Logic Spectra 12000 User Manual page 120

120 Spectra 12000 User Guide
5. Select the slot (from Tape Slots box) that holds the media you wish to
eject. Then select a slot in the Entry/Exit Port box.
6. Tap Move.
7. Tap Open/Close. A window pops up asking Open Entry/Exit Port? Tap
OK. This opens the E/E port.
8. Remove the media.
9. Tap Open/Close. A window pops up asking Close Entry/Exit Port? Tap
OK. This closes the E/E port.
Note: To remove all Queued tapes, tap Eject Queued Tapes.
The Library Controller will find all the tapes that have
been queued for eject and move them to the E/E port.
We recommend you use your backup software to move tapes. However,
from the Inventory screen, you can also:
Š
Identify the contents of every slot in the library, and in the E/E port.
Š
Identify the contents of every drive.
Š
Move all tapes from the E/E cartridge packs into the current partition
(using the Bulk Load button).
Š
Move cartridges from the source location (slot or drive) to a
destination you specify (slot or drive). To move tapes, select a
partition and use the +/- buttons to select a cartridge pack. Then
select the tape you wish to move, the move destination, and tap
Move.