To Set Ip Addresses; Checking Inventory; Inserting And Ejecting Cartridges - Spectra Logic Spectra 12000 User Manual

116 Spectra 12000 User Guide
Š
NDMP. For more information, see Setting Up NDMP Enabled by TAOS
on page 100.
Š
Serverless Backup. For more information, see Configuring the F-QIP
for Serverless Backup on page 61.
Š
Remote Library Controller

To Set IP Addresses

Select DHCP if your network provides IP addresses through DHCP, or
select Use Static Address if you want to assign an IP address.
To assign an IP address, enter the IP address, Subnet Mask and Gateway
that you want the library to use, and then tap Set Address.

Checking Inventory

To see more data about inventory, and to insert/eject/move media
elements:
Tap Inventory in the General toolbar, Media on the General Status screen,
or the tape icon on the bottom of the screen.

Inserting and Ejecting Cartridges

We recommend you use the Inventory screen only for inserting new
media or to remove ejected tapes from the E/E port. Use your backup
software to move AIT cartridges and to eject backups for offsite and
offline storage.