Table of Contents
Advertisement
Table 54 Advanced Application > Mirroring (continued)
LABEL
Apply
Cancel
16.3 RMirror-Source Screen
Use this screen to set the RMirror VLAN ID, configure the mirroring port and specify the traffic flow to be
copied when the Switch is the source device in remote port mirroring.
Click the RMirror-Source link in the Mirroring screen. The following screen opens.
Figure 83 Advanced Application > Mirroring > RMirror-Source
Chapter 16 Mirroring
DESCRIPTION
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these changes if
it is turned off or loses power, so use the Save link on the top navigation panel to save your changes
to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
MES3500-24S/MGS3520 Series User's Guide
152
Advertisement
Table of Contents
Troubleshooting
