ZyXEL Communications MES3500-24S User Manual page 39

Table 5 Navigation Panel Links (continued)
LINK DESCRIPTION
Multicast This link takes you to screen where you can configure various multicast features, IGMP
snooping and create multicast VLANs.
AAA This link takes you to a screen where you can configure authentication, authorization and
accounting services via external servers. The external servers can be either RADIUS (Remote
Authentication Dial-In User Service) or TACACS+ (Terminal Access Controller Access-Control
System Plus).
IP Source Guard This link takes you to screens where you can configure filtering of unauthorized DHCP and ARP
packets in your network.
Loop Guard This link takes you to a screen where you can configure protection against network loops that
occur on the edge of your network.
VLAN Mapping This link takes you to screens where you can configure VLAN mapping settings on the Switch.
Layer 2 Protocol This link takes you to a screen where you can configure L2PT (Layer 2 Protocol Tunneling)
Tunneling settings on the Switch.
sFlow This link takes you to screens where you can configure sFlow settings on the Switch.
(MGS320 Series)
PPPoE This link takes you to screens where you can configure how the Switch gives a PPPoE
termination server additional subscriber information that the server can use to identify and
authenticate a PPPoE client.
Errdisable This link takes you to a screen where you can configure CPU protection and error disable
recovery.
Private VLAN This link takes you to a screen where you can block traffic between ports in a VLAN on the
Switch.
Green Ethernet This link takes you to a screen where you can configure green Ethernet settings in EEE, auto
power down, and short reach for each port.
LLDP This link takes you to screens where you can configure LLDP settings.
IP Application
Static Routing This link takes you to a screen where you can configure static routes. A static route defines
how the Switch should forward traffic by configuring the TCP/IP parameters manually.
DiffServ This link takes you to screens where you can enable DiffServ, and set DSCP-to-IEEE802.1p
mappings.
DHCP This link takes you to screens where you can configure the DHCP settings.
ARP Setup This link takes you to screens where you can configure the ARP learning settings for each port.
Management
Maintenance This link takes you to screens where you can perform firmware and configuration file
maintenance as well as reboot the system.
Access Control This link takes you to screens where you can change the system login password and configure
SNMP and remote management.
Diagnostic This link takes you to screens where you can view system logs and can test port(s).
Syslog This link takes you to screens where you can setup system logs and a system log server.
Cluster This link takes you to a screen where you can configure clustering management and view its
Management status.
MAC Table This link takes you to a screen where you can view the MAC address and VLAN ID of a device
attached to a port. You can also view what kind of MAC address it is.
ARP Table This link takes you to a screen where you can view the MAC address – IP address resolution
table.
Path MTU Table This link takes you to a screen where you can view the path MTU aging time, index,
destination address, MTU, and expire settings.
Chapter 4 The Web Configurator
MES3500-24S/MGS3520 Series User's Guide
39