Maintenance; Engine; Throttle Cable Adjustment - Hayter 481S Owner's Handbook Manual

1.24

MAINTENANCE

WARNING - PREVENT ACCIDENTS: Stop the engine
disconnect the spark plug lead and the negative battery
lead before attempting to carry out maintenance proce-
dures on the mower.

ENGINE

1. Engine Cowl
2. Carburettor
Spark Plug / Lead
3.
Muffler Guard
4.
Muffler
5.
6. Oil filler Cap/ Dipstick
7. Start Grip
8. Fuel Cap
9. Finger Guard
10. Air Cleaner

THROTTLE CABLE ADJUSTMENT

Remove two screws securing the engine cowl and remove
the cowl to expose the throttle mechanism on the front of the
engine. Loosen the outer cable clamp screw (1) and move
the governor control lever (2) to the left as far as possible.
Insert a large, flat blade screw driver (3) into the slot in the
engine control bracket (4) at the angle shown. Push the gov-
ernor control lever to the right until it just touches the screw
driver blade. Move the throttle control lever to the 'fast'
position (not the 'choke' position) and re-tighten the outer
cable clamp screw. Replace the engine cowl.
MAINTENANCE
1.24
3
2
CS039
481141EB030299A
1
4