configure the diskette drive as a startup device. See "Using the
Configuration/Setup Utility program" on page 27.
4.
From the main menu, select Update System Management Firmware and press
Enter.
5.
Follow the on-screen instructions to complete the update.
If there is an error in loading the ASM software, try installing the software again.
ASM Firmware Update Utility diskette menu choices
The main menu options are as follows:
•
Hardware Status and Information
•
Configuration Settings
•
Update System Management firmware
•
Exit
Use the up-and-down arrow keys to highlight the options. Online help is available
for each option by pressing F1 while the option is highlighted. General Help is
available by pressing F1 from one of the Help windows. To select an option, highlight
it and then press Enter.
Hardware Status and Information
Select Hardware Status and Information for information on the current state of the
ASM processor. When you finish viewing this information, press Esc to return to the
main menu.
Configuration Settings
Select Configuration Settings to view or change the configuration settings of the
ASM processor. Select this choice to configure the following settings:
•
Alert Settings
•
Dial In/Out Settings
•
General Settings
•
Modem Settings
Alert Settings: Select this choice to enable or disable all critical, non-critical, and
system alerts supported by the ASM processor.
Use the arrow keys and the Tab key to move between the fields. Use the left and right
arrow keys to enable or disable each of the alerts. When you finish, press F6 to save
and return to the main menu. To return to the main menu without saving, press Esc.
Dial In/Out Settings: Select this choice to configure dial in and dial out settings.
To use Dial In, use the Tab key or the arrow keys to move the cursor to User Profile to
Configure. Then, use the left and right arrow keys to select a User Profile. When you
have selected a User Profile, you can set the following values:
•
Login ID
•
Password
•
Dialback (enable or disable)
•
Number (used for dialback only)
•
Read Only Access (enable or disable)
37
Configuration