IBM IntelliStation R Pro Hardware Maintenance Manual page 72

4.
5.
6.
7.
8.
9.
10. Connect one end of the ASM link cable (Category 5 cable) to the ASM
64
Hardware Maintenance Manual: xSeries 330 Type 8674 and IntelliStation R Pro Type 6851
Remove the expansion-slot cover from PCI slot 2. Store it in a safe place for future
use.
Attention: Expansion-slot covers must be installed in all vacant slots. This
maintains the electronic emission characteristics of the server and ensures proper
cooling of server components.
Remove the adapter from the static-protective package.
Attention: Avoid touching the components and gold-edge connectors on the
adapter.
Install the adapter as follows:
a. Carefully grasp the adapter by its top edge or upper corners, and align it with
PCI slot 2 on the system board.
Note: You must install the Remote Supervisor Adapter in PCI slot 2.
b. Press the adapter firmly into the PCI slot. Be sure it is firmly seated.
Attention: When you install the adapter in the server, be sure that it is
completely and correctly seated in the system-board connector before you
apply power. Incomplete insertion might cause damage to the system board
or the adapter. Note that power can also be provided to the adapter through
the system management connector (for the location of this connector, see
"Remote Supervisor Adapter components" on page 62).
Connect the internal cables to the adapter. Note that the 20-pin ribbon cable (see
"Inventory checklist" on page 60), which connects the system management
connector on the Remote Supervisor Adapter to the system board at J57 (see
"System board options connectors" on page 44), also supplies power to the
adapter.
Attention: Route cables so that they do not block the flow of air from the fans.
Replace the cover on the server; then, reinstall the server in the rack (if applicable)
and connect all external cables.
Connect the ASM Interconnect module to the Remote Supervisor Adapter using
the ASM Interconnect port (P-P port) that is located on the adapter.
Interconnect module, and the other end to the ASM Interconnect port that is
located on the back of your server.