Table of Contents
Advertisement
Error Code/Symptom
1600 (The Service Processor is not
functioning) Do the following before
replacing a FRU:
1601 (The system is able to communicate
to the Service Processor, but the Service
Processor failed to respond at the start of
POST.)
1762 (Fixed Disk Configuration error)
(IDE drive only)
178X (Fixed Disk error) (IDE drive only)
1800 (No more hardware interrupt
available for PCI adapter)
1801 (no more ROM space available for
PCI adapter)
1962 (Drive does not contain a valid boot
sector)
2400 (Video controller test failure)
2462 (Video memory configuration error)
5962 (IDE CD-ROM configuration error)
132
Hardware Maintenance Manual: xSeries 330 Type 8674 and IntelliStation R Pro Type 6851
1.
Do the following before replacing a FRU:
a.
Ensure that a jumper is not installed on J28.
b.
Remove the ac power to the system, wait 20 seconds; then, re-
connect the ac power. Wait 30 seconds; then, power-on the
system.
2.
System Board
1.
Do the following before replacing a FRU:
a.
Remove the ac power to the system, wait 20 seconds; then, re-
connect the ac power. Wait 30 seconds; then, power-on the
system.
b.
Flash update the Service Processor.
2.
System Board
1.
Fixed Disk Drive
2.
Fixed Disk Cables
3.
Run Configuration/Setup
4.
System Board
1.
Fixed Disk Cables
2.
Run Diagnostics
3.
Fixed Disk Drive
4.
System Board
1.
Run Configuration/Setup
2.
Remove Adapter
1.
Run Configuration/Setup
2.
Remove adapter
3.
Disable adapter BIOS on adapter and run Configuration/Setup
1.
Verify a bootable operating system is installed.
2.
Run Diagnostics
3.
Hard Disk Drive
4.
SCSI Backplane
5.
Cable
6.
System Board
1.
Video Adapter (if installed)
2.
System Board
1.
Video Adapter (if installed)
2.
System Board
1.
Run Configuration/Setup
2.
CD-ROM Drive
3.
CD-ROM Power Cable
4.
IDE Cable
5.
System Board
6.
Battery
FRU/Action
Advertisement
Table of Contents
