Diagnostic error codes
Error Code/Symptom
001-XXX-000 (Failed core tests)
001-XXX-001 (Failed core tests)
001-250-000 (Failed System Board ECC)
001-250-001 (Failed Processor Board ECC)
005-XXX-000 (Failed Video test)
011-XXX-000 (Failed COM1 Serial Port test)
011-XXX-001 (Failed COM2 Serial Port test)
014-XXX-000 (Failed Parallel Port test)
015-XXX-001 (USB interface not found,
board damaged)
015-XXX-198 (USB device connected during
USB test)
020-XXX-000 (Failed PCI Interface test)
030-XXX-000 (Failed Internal SCSI interface
test)
035-XXX-099
035-XXX-S99 (Failed RAID test on PCI slot
S, check System Error Log before replacing
a FRU)
035-XXX-SNN (Check System Error Log
before replacing a FRU, NN = SCSI ID of
failing fixed disk)
Note: In the following error codes, if XXX is 000, 195, or 197 do not replace a FRU.
The description for these error codes are:
000
The test passed.
The Esc key was pressed to abort the test.
195
197
This is a warning error and may not indicate a hardware failure.
For all error codes, replace/follow the FRU/Action indicated.
1.
1.
1.
1.
1.
2.
1.
2.
3.
1.
2.
3.
1.
1.
1.
2.
1.
1.
1.
2.
1.
2.
3.
1.
System Board
System Board
System Board
System Board
Video adapter (if installed)
System Board
Check loopback plug connected to externalized serial port
Check cable from externalized port to system board. Should connect
to Serial Port A on the system board (J52).
System Board
Check loopback plug connected to externalized serial port
Check cable from externalized port to system board. Should connect
to Serial Port B on the system board (J51).
System Board
System Board
System Board
Remove USB devices from USB1 and USB2.
System Board
System Board
System Board
No RAID adapters were found.
If adapter is installed re-check connection.
RAID Adapter
SCSI Backplane
Cable
Fixed Disk with SCSI ID NN on RAID adapter in PCI slot S.
FRU/Action
Symptom-to-FRU index
125