The Replacement For Light Signal - VOGE SR1 Operation Manual

The replacement for light signal

·If there is no light signal, you may be in danger, because the light helps others easily pay attention to you and your
motorcycle.
Please replace the broken lights.
·The headlight, front position light, turning signal light, rear position light, brake light and registration plate light are all LED
and sealed, in case broken, go to the service station for replacement. The replacement for lights please follow the
description and specification below:
The dirt especially the grease on light's surface may be bad for heat radiation, which lead to light overheat even reduce
its working life.
When a signal light is broken, replace for a new one with completely same rating power and specification,
otherwise the different one may lead to electrical circuit overload or light broken very early.
Parameters for electrical system
Battery specification
Headlight (High/Low beam)
Front position light
Rear position light
Rear brake light
Front turning signal light
Rear turning signal light
Rear registration plate light
Specification for fuse chip
12V8Ah
12V 33W/14W
12V 4.8W
12V 0.5W
12V 12.6W
12V 1.2W
12V 6W
12V 0.257W
30A, 25A, 15A, 10A
!
Warning
60