VOGE SR1 Operation Manual page 52

Oil filling up for engine
·Confirm that the oil filter has been replaced and the valve cover assembly is complete.
·Confirm the oil drainage bolt and sealing washer are both replaced and re-assembled.
Fill up with new oil from the filling-up port on crankcase with volume of 900mL (Refuel 800mL during maintenance), fill up
new gear oil from the filling-up port on gear box with volume of 200mL (Refuel 120mL during maintenance), Start the engine
to let it idly run for seconds.
Stop the engine and wait for one minute, Remove the oil gauge to check the oil level, when checking, the motorcycle
must be horizontally upright, in case the oil level is under lower scale mark, please fill up to the middle position between
upper and lower scale marks.
Replace the oil when engine is warm.
Specification of oil: For crankcase, SAE 10W-40-SL or above
Dispose the replaced old oil, or above with volume of 0.9L,for gear
box, 80W/90 GL-4 with volume of 0.2L. Dispose the replaced old oil
and element in environment friendly way.
Wrong oil specification or bad oil may damage the engine, EFI system and shorten the working life of spark plug
and catalyst in muffler, don't use them.
!
Caution
!
Warning
20W-50
15W-40
10W-40
5W-40
℃
-35 -30 -20 -10 0 10 20 30
-31 -22 -4 14 32 50 68 86
If you need to use them in winter,please
exchange 5W-40 or 0W-40 low temperature
resistant oil and you need to exchange
10W-40 or 20W-50 oil again in Summer.
20W-50
15W-40
10W-40
5W-40
40 50
104 122
48