External Power Supply - VOGE SR1 Operation Manual

Disassembly and re-assembly for battery
· Before the disassembly and re-assembly, turn off the ignition
switch first.
· Remove the negative terminal first when disassembling the battery,
then the positive one.
· Install the positive terminal first when re-assembling, then the
negative one.
· Every time when re-assembled the battery, turn on the ignition switch
for 1 minute and then turn off to let the electrical equipment initialize.

External power supply

·When the power in battery fail to start engine, the outer
power source could be adopted for engine starting.
· When the outer power source is adopted, use the wire clip for spring only of
completely insulated to avoid short cut or non-jump spark between guiding wires.
The battery A is the power source on motorcycle while the battery B is an outer one.
The positive terminal 1 on outer power source B connect to positive terminal 2 on
power source A on motorcycle, while the negative terminal 3 connect to the metallic
part C on engine to connect the ground. Start the engine, in case failed, wait for
minutes and then start once again to protect the engine and battery.
Before removing the guiding wire of outer power source, let engine run for minutes,
then cut off the negative wire and ground wire first, then the positive wire.
43
!
Warning
Don't put the battery up side down, otherwise the
electrolyte may flow out from the breathing hole.