Table of Contents
Advertisement
CAUTION!
Risk of injury due to unexpected movements of the device!
The device head may perform fast movements and generate very bright light. This is the case immediately after the device is
switched on, in automatic or remote operation, and when a connected DMX controller is switched off. Persons who are in the
immediate vicinity of the device may be injured or frightened by this. Make sure that there are no obstacles within the movement
range of the mirror, and that no persons are in the immediate vicinity of the head before switching it on and during its operation.
Switch off the device before any work is performed in the movement range or immediate vicinity of the device, or if unauthorised
persons are in that area.
NOTICE!
Risk of fire due to covered vents and neighbouring heat sources!
If the vents of the device are covered or the device is operated in the immediate vicinity of other heat sources, the device can
overheat and burst into flames. Never cover the device or the vents. Do not install the device in the immediate vicinity of other
heat sources. Never operate the device in the immediate vicinity of naked flames.
NOTICE!
Damage to the device if operated in unsuitable ambient conditions!
The device can be damaged if it is operated in unsuitable ambient conditions. Only operate the device indoors within the
ambient conditions specified in the "Technical specifications" chapter of this user manual. Avoid operating it in environments
with direct sunlight, heavy dirt and strong vibrations. Avoid operating it in environments with strong temperature fluctuations. If
temperature fluctuations cannot be avoided (for example after transport in low outside temperatures), do not switch on the
device immediately. Never subject the device to liquids or moisture. Never move the device to another location while it is in oper‐
ation. In environments with increased dirt levels (for example due to dust, smoke, nicotine or mist): Have the device cleaned by
qualified specialists at regular intervals to prevent damage due to overheating and other malfunctions.
NOTICE!
Damage to the device due to high voltages!
The device can be damaged if it is operated with the incorrect voltage or if high voltage peaks occur. In the worst case, excess
voltages can also cause a risk of injury and fires. Make sure that the voltage specification on the device matches the local power
grid before plugging in the device. Only operate the device from professionally installed mains sockets that are protected by a
residual current circuit breaker (FI). As a precaution, disconnect the device from the power grid when storms are approaching or it
the device will not be used for a longer period.
NOTICE!
Risk of fire by exceeding the maximum current
The device can supply power to other devices of identical design and connected in series. If too many devices are connected, the
power consumption can exceed the maximum permitted power consumption, which can cause the device to overheat and burst
into flames. Only connect devices of identical design to the device. When deciding how many devices you can connect in series,
make sure that the maximum permitted power consumption as stated on the device is not exceeded. Also refer to the specifica‐
tions in the technical specifications for the device. Only use power cords with a cable cross-section designed for the required
current intensity when connecting the devices in series.
NOTICE!
Possible staining due to plasticiser in rubber feet!
The plasticiser contained in the rubber feet of this product may react with the coating of the floor and cause permanent dark
stains after some time. If necessary, use a suitable mat or felt slide to prevent direct contact between the device's rubber feet and
the floor.
NOTICE!
Risk of overheating and fire due to inadequate distance and bad ventilation!
If the distance between the light source and the illuminated surface is too short or the device is badly ventilated, the device can
overheat and cause fires. Make sure that illuminated surfaces are more than 2 m away. Do not operate the device in ambient
temperatures above 40 °C. Always ensure sufficient ventilation at the operating location.
Safety instructions
Tristan 200
7
Moving Head
Advertisement
Table of Contents
