Table of Contents
Advertisement
Operation
Selecting the unit for the temperature
display
Setting the display warning
Performing an automatic self test
Performing a manual self test
Tristan 200
16
Moving Head
1.
Open the main menu.
2.
Navigate to 'Display Settings è Temperature Unit'.
3.
Use [UP] and [DOWN] to select the '°C' (degrees Celsius) or '°F' (degrees Fah‐
renheit) submenu.
4.
Confirm your selection with [ENTER].
ð The desired setting is saved.
5.
To exit the menu, press [MENU], or wait 30 seconds.
1.
Open the main menu.
2.
Navigate to 'Display Settings è Display Warning'.
3.
Use [UP] and [DOWN] to select 'Off' (display warning switched off) or 'On' (dis‐
play warning switched on).
4.
Confirm your selection with [ENTER].
ð The desired setting is saved.
5.
To exit the menu, press [MENU], or wait 30 seconds.
1.
Open the main menu.
CAUTION!
Risk of injury due to unexpected movements of the device!
The device head may perform fast movements and generate very bright
light. This is the case immediately after the device is switched on, in
automatic or remote operation, and when a connected DMX controller
is switched off. Persons who are in the immediate vicinity of the device
may be injured or frightened by this.
Make sure that there are no obstacles within the movement range of
the mirror, and that no persons are in the immediate vicinity of the head
before switching it on and during its operation.
Switch off the device before any work is performed in the movement
range or immediate vicinity of the device, or if unauthorised persons are
in that area.
2.
Navigate to 'Auto Test'.
ð The device immediately performs an automatic self test. The following
functions are tested: Pan, Tilt, Color, Gobos, Gobo rotation, Prism, Prism
rotation, Frost, Focus, Strobe and Dimmer.
3.
To end the automatic self test and exit the menu, press [MENU], or wait 30 sec‐
onds.
1.
Open the main menu.
2.
Navigate to 'Manual Test'.
ð The current channel is displayed.
Advertisement
Table of Contents
