Table of Contents
Advertisement
Displaying device information
Displaying and resetting LED informa‐
tion
3.
Use [UP] and [DOWN] to select the channel for which the self test is to be per‐
formed.
4.
Confirm your selection with [ENTER].
5.
Use [UP] and [DOWN] to select the type of self-test (Pan, Tilt, Color, Gobos,
Gobo rotation, Prism, Prism rotation, Frost, Focus, Strobe or Dimmer).
CAUTION!
Risk of injury due to unexpected movements of the device!
The device head may perform fast movements and generate very bright
light. This is the case immediately after the device is switched on, in
automatic or remote operation, and when a connected DMX controller
is switched off. Persons who are in the immediate vicinity of the device
may be injured or frightened by this.
Make sure that there are no obstacles within the movement range of
the mirror, and that no persons are in the immediate vicinity of the head
before switching it on and during its operation.
Switch off the device before any work is performed in the movement
range or immediate vicinity of the device, or if unauthorised persons are
in that area.
6.
Confirm your selection with [ENTER].
ð The device immediately performs the selected self test. The selected
channel is displayed.
7.
To end the self test and exit the menu, press [MENU], or wait 30 seconds.
The device returns to its original DMX state after the self test. The test
values are saved automatically when the device is switched off.
1.
Open the main menu.
2.
Navigate to 'Information'.
3.
Use [UP] and [DOWN] to select the 'Fixture Use Hour' , 'Temperature' , 'Fan
State' , 'Firmware Version' or 'RDM UID' submenu.
4.
Confirm your selection with [ENTER].
ð Depending on your selection, the operating hours, the device tempera‐
ture, the fan status, the firmware version or the RDM UID is displayed.
5.
To exit the menu, press [MENU], or wait 30 seconds.
1.
Open the main menu.
2.
Navigate to 'Information è LED Use Hour'.
3.
Use [UP] and [DOWN] to select the 'Total LED Hour' (total time) or 'LED On
Hour' (current switch-on time) submenu.
4.
Confirm your selection with [ENTER].
ð The desired selection is saved.
5.
Use [UP] and [DOWN] to select the 'LED Hours Reset' submenu.
Operation
Tristan 200
17
Moving Head
Advertisement
Table of Contents
