Table of Contents
Advertisement
Operation
Displaying and resetting an error log
Resetting individual functions
Reset to factory defaults
Tristan 200
18
Moving Head
6.
Confirm your selection with [ENTER].
7.
If you wish to reset the relevant LED operating hours, select 'Yes' . If you do not
wish to reset anything, select 'No' .
8.
Confirm your selection with [ENTER].
ð A three-digit PIN is displayed.
9.
Use [UP] and [DOWN] to enter the digits '050' .
10.
Confirm your input with [ENTER].
ð The previously selected LED operating hours are reset.
11.
To exit the menu, press [MENU], or wait 30 seconds.
1.
Open the main menu.
2.
Navigate to 'Information è Error Logs'.
3.
Use [UP] and [DOWN] to select the 'Fixture Errors' submenu.
4.
Confirm your selection with [ENTER].
ð The desired selection is saved.
5.
Use [UP] and [DOWN] to select the 'Reset Error Log' submenu.
6.
Confirm your selection with [ENTER].
7.
If you wish to reset the relevant error logs, select 'Yes' . If you do not wish to
reset anything, select 'No' .
8.
Confirm your selection with [ENTER].
ð If you selected 'Yes' , a three-digit PIN is displayed; otherwise the previous
submenu is displayed again.
9.
Use [UP] and [DOWN] to enter the digits '050' .
10.
Confirm your input with [ENTER].
ð The error logs are reset.
11.
To exit the menu, press [MENU], or wait 30 seconds.
1.
Open the main menu.
2.
Navigate to 'Reset Functions'.
3.
Use [UP] and [DOWN] to select the 'Pan/Tilt Reset' (resets the axis movements),
'Effect Reset' (resets the effects) or 'All Reset' (resets all settings) menu.
4.
Confirm your selection with [ENTER].
5.
If you wish to reset the respective settings, select 'Yes' . If you do not wish to
reset anything, select 'No' .
6.
Confirm your selection with [ENTER].
7.
To exit the menu, press [MENU], or wait 30 seconds.
The menu item 'Factory Restore' gives you the option of resetting the device to its
factory settings.
1.
Open the main menu.
2.
Navigate to 'Factory Restore'.
Advertisement
Table of Contents
