Table of Contents
Advertisement
7
Operation
7.1 Starting the device
7.2 Main menu
How to use the main menu
Setting the DMX address
Specifying the DMX mode
CAUTION!
Risk of injury due to unexpected movements of the device!
The device head may perform fast movements and generate very bright
light. This is the case immediately after the device is switched on, in
automatic or remote operation, and when a connected DMX controller
is switched off. Persons who are in the immediate vicinity of the device
may be injured or frightened by this.
Make sure that there are no obstacles within the movement range of
the mirror, and that no persons are in the immediate vicinity of the head
before switching it on and during its operation.
Switch off the device before any work is performed in the movement
range or immediate vicinity of the device, or if unauthorised persons are
in that area.
Connect the device to the power supply to start operation. After a few seconds, the
fans start to work, the head moves to the home positions for rotation (pan) and incli‐
nation (tilt). After a few more seconds, the device will perform the last automatic
show. The name of the set show appears on the display, e.g. 'Show 1' .
1.
To enter the main menu, press [MENU].
2.
To scroll between the individual menu items, press [UP] and [DOWN]. To open
the selected menu item, press [ENTER].
3.
To exit the menu, press [MENU], or wait 30 seconds.
ð All previous settings are retained even when the device is switched off and
disconnected from the mains.
4.
To restart with default values, use the functions under 'Factory Restore' in the
main menu.
1.
Open the main menu.
2.
Navigate to 'DMX Settings è DMX Address'.
3.
Use [UP] and [DOWN] to select an address between 001 and 495.
4.
Confirm your selection with [ENTER].
ð The desired address is saved.
5.
To exit the menu, press [MENU], or wait 30 seconds.
The device can only be controlled in 18-channel mode. To specify the mode, proceed
as follows:
1.
Open the main menu.
2.
Navigate to 'DMX Settings è Channel Mode'.
3.
Use [UP] and [DOWN] to select 'Mode1(18)' .
Operation
Tristan 200
13
Moving Head
Advertisement
Table of Contents
