Mitsubishi Electric MR-J2S B Series Instruction Manual page 93

5. PARAMETERS
(2) Details list
Classifi-
No. Symbol
cation
1 *AMS Amplifier setting
Used to select the absolute position detection.
2 *REG Regenerative resistor
Used to select the regenerative option used.
3 For manufacturer setting by servo system controller
Automatically set from the servo system controller
4
5
Name and Function
0 0 0
Absolute position detection selection
0: Invalid (Used in incremental system.)
1: Valid (Used in absolute position
0 0
Regenerative selection option
00: Regenerative option is not used with 7kW or
less servo amplifier (The built-in regenerative
resistor is used. However, the MR-J2S-10B
does not have a built-in regenerative resistor
and therefore cannot use it.)
Supplied regenerative resistors or regenerative
option is used with 11k to 22kW amplifier
01: FR-RC, FR-BU2, FR-CV
05: MR-RB32
08: MR-RB30
09: MR-RB50 (Cooling fan is required)
0B: MR-RB31
0C: MR-RB51 (Cooling fan is required)
0E: When regenerative resistors or regenerative
option supplied to 11k to 22kW are cooled by
cooling fans to increase capability
10: MR-RB032
11: MR-RB12
The MR-RB65, 66 and 67 are regenerative options
that have encased the GRZG400-2 ,
GRZG400-1
When using any of these regenerative options,
make the same parameter setting as when using
the GRZG400-2 , GRZG400-1
GRZG400-0.8
regenerative option is used with 11k to 22kW
servo amplifier).
Select the external dynamic brake.
0: Invalid
1: Valid
Select "1" when using the external dynamic brake
with the MR-J2S-11KB to 22KB.
POINT
Wrong setting may cause the regenerative option
to burn.
If the regenerative option selected is not for use
with the servo amplifier, parameter error (37)
occurs.
detection system.)
and GRZG400-0.8 , respectively.
or
(supplied regenerative resistors or
5 - 4
Initial Setting
Unit
Value Range
0000 Refer to
name
and
function
column.
0000 Refer to
name
and
function
column.
0080
0000
1