Comtech EF Data XTRT-400C-BUC Operation And Installation Manual page 130

Parameter Information Requested
'%'
Time and Date
'!'
Extended Summary Status
'#'
Extended Fault Status
'('
Extended Alarm Status
'1'
Summary Status
'3'
Fault Status
'6'
Power
'7'
Power
'8'
Attenuator
"C"
Cathode Current
'9'
Alarm Status
'A'
Attenuator Setting
'H'
High Power Alarm/Fault
Trip point and setting
'h'
High Power Alarm/Fault
Trip point and setting
'I' Helix Current — If you have a TWTA
Body Current — If you have an EIK
'J'
Heater Voltage
MNC-0500-038
EAR EXPORT CONTROLLED: The information contained in this Manual refers or relates to a product that is subject
to the U.S. Export Administration Regulations (EAR). Transfer of data herein by any means to a Foreign Person,
whether in the U.S. or abroad, may require an export license from the U.S. Department of Commerce.
Amplifier Communication and Protocol, XTRT, Touchscreen TWTA
16 Bytes: YYYY/MM/DD, hh:mm
4 bytes
Byte A Summary Status Byte A
Byte B Summary Status Byte B
Byte C
Bit 7 — Reserved
Bit 6 — compliment of Bit 5
Bit 5 — No VPC Controller Found
Bit 4 — Switch 2 Pos B or
(other amp faulted if not 1:2)
Bit 3 — Switch 2 Pos A
Bit 2 — automatic mode
Bit 1 — Waveguide Switch Position B or VPC Position
Bit 0 — Waveguide Switch Position A or VPC Position
00 - VPC Position A
01 - VPC Position B
10 - VPC Position C
11 - VPC Position D
Byte D
Bit 7 — Reserved (Always 0)
Bit 6 — Compliment of Bit 5.
Bit 5 — IF Drive High
Bit 4 — UPC Suspended
Bit 3 — UPC Enabled
Bit 2 — Mode Selected
Bit 1 — Mode Selected
Bit 0 — Mode Selected
ABCD
ABCD
XX
XX
XX.X in dBW
XXXX in Watts
XXXX counts
XXXX in mA
X
XX.X in dB
A XX.X in dBm (generate alarm)
F XX.X in dBm (generate fault)
D XX.X in dBm (disabled)
A XXXX in Watts (generate alarm)
F XXXX in Watts (generate fault)
D XXXX in Watts (disabled)
XX.X in mA
XX.X Volts
17 of 28
Response Format
Revision 2