Comtech EF Data XTRT-400C-BUC Operation And Installation Manual page 131

Parameter Information Requested
'L'
Low Power Alarm/Fault
Trip point and setting
'l'
Low Power Alarm/Fault
Trip point and setting
'M'
Heater Hours
'N'
Beam Hours
'P'
Fwd Power
'Q'
Reverse Power
'X'
Antenna Power
'x'
Load Power
'R'
Reverse Power Alarm/Fault trip point and
setting
'r'
Reverse Power Alarm/Fault
Trip point and setting
'T' TWT Temp — If you have a TWTA
Tube Temp — If you have an EIK
'V' Helix Voltage — If you have a TWTA
Beam Voltage — If you have an EIK
Notes:
Parameters ''Z' and 'z' are only available with HPAs that have the linearizer option.
1
Parameter '/' is only applicable to Linearizers that have the Magnitude slope adjustment option.
2.
MNC-0500-038
EAR EXPORT CONTROLLED: The information contained in this Manual refers or relates to a product that is subject
to the U.S. Export Administration Regulations (EAR). Transfer of data herein by any means to a Foreign Person,
whether in the U.S. or abroad, may require an export license from the U.S. Department of Commerce.
Amplifier Communication and Protocol, XTRT, Touchscreen TWTA
A XX.X in dBm (generate alarm)
F XX.X in dBm (generate fault)
D XX.X in dBm (disabled)
A XXXX in Watts (generate alarm)
F XXXX in Watts (generate fault)
D XXXX in Watts (disabled)
XXXXXX hours
XXXXXX hours
XX.X in dBm
XX.X in dBm
XX.X dBm
XX.X dBm
A XX.X in dBm (generate alarm)
F XX.X in dBm (generate fault)
D XX.X in dBm (disabled)
A XX.X in Watts (generate alarm)
F XX.X in Watts (generate fault)
D XX.X in Watts (disabled)
o
XXXX in Celsius (Right Justified and Padded with Spaces.)
XX.X in KV
18 of 28
Response Format
Revision 2