Speaker
The PCM-5862E/5862EL can drive an 8 Ω speaker at 0.5 watts.
Ensure that alternatives to this specification do not overload the
card.
LED interface
The front panel LED indicator for hard disk access is an active low
signal (24 mA sink rate).
Watchdog output
When PCM-5862E/5862EL watchdog timer times out, the front
panel pin 6 will output an active low pulse signal (25mA sink rate
for 1 second).
Reset switch
If you install a reset switch, it should be an open single pole switch.
Momentarily pressing the switch will activate a reset. The switch
should be rated for 10 mA, 5 V.
If you need to make your own cable, you can find the pin
assignments for the board's connector in Appendix C.
Power connectors (CN6, CN10, CN14)
Peripheral power connector, -5V, -12V (CN10)
Supplies secondary power to devices that require -5 V and -12 V.
Main power connector, +5V, +12V (CN14)
Supplies main power to the PCM-5862E/5862EL (+5 V) and
devices that require +12 V.
Fan power supply connector (CN6)
Provides power supply to optional CPU cooling fan. Only present
when +5 V and +12 V power is supplied to the board.
Chapter 2 Installation
21