Table of Contents
Advertisement
•
The main display area where the menus and pop-up
messages are displayed.
•
The lower line where telltales, menu name and
menu page are displayed.
The system allows the driver to select information by
pushing the following buttons mounted on the steering
wheel:
Instrument Cluster Display Control Buttons
1 — Left Arrow Button
2 — Up Arrow Button
3 — Right Arrow Button
4 — Down Arrow Button
5 — OK Button
Up
And Down
Arrow Buttons:
Using the up
or down
arrow button allow you to
cycle through the Main Menu Items.
They allow you to change the Main Screen area and
Menu Title area.
Left
And Right
Arrow Buttons:
Using the left
or right
arrow button allow you to
cycle through the submenu screens of the Main menu
item.
OK Button
Push the OK button to access/select the information
screens or submenu screens of a main menu item. To
reset displayed/selected features push and hold the OK
button for two seconds.
OIL LIFE RESET — IF EQUIPPED
Your vehicle may be equipped with an engine oil change
indicator system. The "Oil Change Required" message
will display in the instrument cluster display for five sec-
onds after a single chime has sounded to indicate the
next scheduled oil change interval. The engine oil
change indicator system is duty cycle based, which
means the engine oil change interval may fluctuate,
dependent upon your personal driving style.
Unless reset, this message will continue to display each
time you place the ignition in the ON/RUN position. To
turn off the message temporarily, push and release the
OK button. To reset the oil change indicator system
(after performing the scheduled maintenance), refer to
the following procedure.
Oil Life Reset
1. Without pushing the brake pedal, place the ignition
in the ON/RUN mode (do not start the engine).
2. Navigate to "Oil Life" submenu in "Vehicle Info" in the
instrument cluster display.
3. Push and hold the OK button until the gauge resets
to 100%.
GETTING TO KNOW YOUR INSTRUMENT PANEL
Secondary Method For Oil Change Reset Procedure
1. Without pushing the brake pedal, place the ignition
in the ON/RUN position (do not start the engine).
2. Fully press the accelerator pedal, slowly, three times
within ten seconds.
3. Without pushing the brake pedal, place the ignition
in the OFF position.
NOTE:
If the indicator message illuminates when you start the
vehicle, the oil change indicator system did not reset. If
necessary, repeat this procedure.
OFF ROAD+ DISPLAY —
IF EQUIPPED
When the Off Road+ button is pushed in the switch
bank, the Instrument Cluster Display will begin to show
messages related to the feature. Depending on the
Four-Wheel Drive mode in use, the messages will differ,
and after five seconds, all messages will clear from the
display. The messages are as follows:
•
2H: Off Road+ Unavailable, Shift to 4WD
•
4H: 4WD High Off Road+ Active
•
4L: 4WD Low Off Road+ Active
Adaptive Cruise Control (ACC) and Cruise Control are
not available when using Off Road+. If either option is
selected, a dedicated message will display indicating
that the features are not usable concurrently. Mes-
sages are as follows:
•
4H: Cruise Control — Cruise Control Unavailable in
Off Road+
•
4H: Adaptive Cruise Control — Adaptive Cruise Con-
trol (ACC) Unavailable in Off Road+
105
3
Hide quick links:
Advertisement
Table of Contents
