Jeep GLADIATOR 2022 Owner's Manual page 291

WARNING!
•
Do not get under the vehicle when it is on a jack. If
you need to get under a raised vehicle, take it to a
service center where it can be raised on a lift.
•
Only use the jack in the positions indicated and for
lifting this vehicle during a tire change.
•
If working on or near a roadway, be extremely care-
ful of motor traffic.
•
To assure that spare tires, flat or inflated, are
securely stowed, spares must be stowed with the
valve stem facing the ground.
Warning Label
CAUTION!
Do not attempt to raise the vehicle by jacking on loca-
tions other than those indicated.
1. Remove the spare tire, jack and tools from the
stored location.
2. Using the lug wrench, loosen the wheel nuts (but do
not remove) by turning them counterclockwise one
turn while the wheel is still on the ground.
3. Assemble the jack and jacking tools. Connect the
jack handle driver to the extension, then to the lug
wrench.
Assembled Jack And Tools
4. Operate the jack from the front or the rear of the
vehicle. Place the jack under the axle tube, as
shown. Placement for the front and rear jacking
locations are critical. See the following images for
proper jacking locations. Do not raise the vehicle
until you are sure the jack is fully engaged.
IN CASE OF EMERGENCY
Front Jack Lifting Point
NOTE:
Keep the jack and tools aligned while raising the
vehicle to prevent tool damage.
Front Jacking Location
289
7