Jeep GLADIATOR 2022 Owner's Manual page 80

78 GETTING TO KNOW YOUR VEHICLE
Installing The Rear Window And Quarter
Panel Cover Assemblies
NOTE:
Both quarter panel cover assemblies and the rear win-
dow must ALL be removed together, or installed
together.
If the rear window and quarter panel cover assemblies
were previously removed, proceed as follows to install:
1. Guide the top of the quarter panel cover assembly
up into the retainer.
Step One
CAUTION!
Failure to follow all quarter panel cover assembly and
rear window install steps could result in damage to
the Soft Top or vehicle.
2. Engage the plastic retainers on the front of the
cover assembly (toward the front of the vehicle)
starting at the top, and working downward.
Step Two
NOTE:
It is critical that the retainers are fully engaged
before the vehicle resumes motion.
3. Secure the hook-and-loop fastener at the upper
front corner of each quarter panel cover assembly
by pressing firmly.
Step Three
4. From either side, guide the rear window into the
retainer while keeping the window level.
Step Four
5. Engage the retainer along the bottom of the rear
window beginning on the left side of the vehicle and
working toward the center. Then, move to the right
side of the vehicle and continue from the center,
working to the right until the rear window is secured
in the lower retainer.
Step Five