Auxiliary Switches - If Equipped - Jeep GLADIATOR 2022 Owner's Manual

68 GETTING TO KNOW YOUR VEHICLE
The power inverter is designed with built-in overload
protection. If the power rating of 400 W is exceeded,
the power inverter automatically shuts down. Once the
electrical device has been removed from the outlet, the
inverter should automatically reset.
NOTE:
•
The Power Inverter will only turn on if the ignition is
in the ACC or ON/RUN position.
•
Due to built-in overload protection, the power
inverter will turn off if the power rating is exceeded.
WARNING!
To avoid serious injury or death:
•
Do not insert any objects into the receptacles.
•
Do not touch with wet hands.
•
Close the lid when not in use.
•
If this outlet is mishandled, it may cause an elec-
tric shock and failure.
AUXILIARY SWITCHES —
IF EQUIPPED
Four auxiliary switches are located in the lower switch
bank of the instrument panel and can be used to power
various electrical devices.
The functionality of the auxiliary switches can be
changed via the Uconnect Settings. All switches can be
configured for setting the switch type operation to latch-
ing or momentary, power source of either battery or
ignition, and ability to hold last state across key cycles.
Auxiliary Switches
NOTE:
Holding last state conditions are met when switch type
is set to latching and power source is set to ignition
within Uconnect Settings page 181.
The auxiliary switches manage the relays that power
four blunt cut wires. These wires are located under the
instrument panel in the passenger compartment and
under the hood to the right, near the battery.
Auxiliary Switch Connections — Under Hood
Auxiliary Switch Connections – Under Instrument Panel
In addition to the four auxiliary switch wires, a fused
battery wire and ignition wire are also located in the
interior, on the passenger side under the instrument
panel.
A kit of splices and heat shrink tubing are provided with
the auxiliary switches to aid in the connection/
installation of your electrical devices.