Table of Contents
Advertisement
Feeding Sheet Film
Caution
• The Kodak M35M and M35A-M X-Omat PROCESSORS process only sheet film.
• Feeding other than sheet film may result in transport problems and damage to the components in the processing
racks.
Film Sizes and Direction of Film Feed
Figure 6
1 each
35 x 43 cm
or
14 x 17 in.
1 each
24 x 30 cm
or
10 x 12 in.
2 each
18 x 24 cm
981799 - 09JUL98
1 each
35 x 35 cm
or
14 x 14 in.
1 each
24 x 24 cm
1 each
2 each
10 x 10 cm
or
4 x 4 in.
18 x 43 cm
1 each
11 x 14 in.
H112_9004CC
Use only qualified service personnel to perform
all necessary adjustments and procedures.
[1] Press the Run/Standby Switch.
Note
• The motors will begin to operate.
• After film removal, the PROCESSOR will
automatically return to the standby mode.
• During operation, the Digital Temperature Display
indicates when the developer is at the correct
temperature for a film to be fed.
[2] Feed a sheet of film into the PROCESSOR. See
Figure 6 for the correct sizes and direction to feed
films into the PROCESSOR.
Note
A film feed signal will sound 8 seconds after the trailing
edge of a sheet of film has left the rollers of the Detector
Crossover Assembly.
Run/Standby Switch and Digital
Figure 7
Temperature Display
DIGITAL
TEMPERATURE
DISPLAY
Processing Film
RUN/STANDBY
SWITCH
H112_0043ACB
H112_0043AC
7
Advertisement
Table of Contents
