Removing The Cd Drive - IBM System x3800 Manual

3. Install the I/O board (see "Replacing the I/O board" on page 140).
4. Install the top cover (tower model only) and lock the front cover (see "Replacing
5. Reconnect the external cables; then, reconnect the power cords and turn on the
6. Start the Configuration/Setup Utility program and reset the configuration:

Removing the CD drive

To remove a CD drive, complete the following steps.
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Turn off the server and peripheral devices, and disconnect the power cords and
3. (Tower model only) Remove the front cover (see "Removing the top cover,
4. Press on the blue retention latches on each side of the drive and pull the CD
a. Position the battery so that the positive (+) symbol is facing away from you.
b. Use one finger to press the top of the battery clip away from the battery.
c. Press the battery into the socket until it clicks into place. Make sure that the
battery clip holds the battery securely.
the top cover, bezel, and front cover" on page 121).
peripheral devices and the server.
Note: You must wait approximately 20 seconds after you connect the power
cord of the server to an electrical outlet before the power-control button
becomes active.
v Set the system date and time.
v Set the power-on password.
v Reconfigure the server.
See "Using the Configuration/Setup Utility program" on page 158 for details.
on page 115.
all external cables necessary to replace the device.
bezel, and front cover" on page 119).
drive out of the server.
Chapter 4. Removing and replacing server components
137