Machine Control (Mode Rc - On) - EWM Tetrix 352 AC/DC SYNERGIC PL. AW GR Operating Instructions Manual

Machine description – quick overview

Machine control (Mode RC - on)

4.3 Machine control (Mode RC - on)
This welding machine is operated in the „RC – on, remote-controlled" mode as a factory
setting.
RC - on: The machine is operated via an external interface in this mode. The majority of the
RC - off: The welding machine is operated via the machine control.
Refer to the „Machine configuration menu" chapter to switch between the operating
modes.
Item Symbol
1
2
3
20
machine control's operating elements will be deactivated and are only used to
monitor the welding data.
Description 0
Tungsten electrode diameter / Ignition optimisation / Spherical cap formation button
∅ 1.0mm, ∅ 1.6mm, ∅ 2.0mm, ∅ 2.4mm, ∅ 3.2mm, ∅ 4.0mm or greater
Best ignition and stabilisation of the arc (DC, AC) and optimum spherical cup formation
in the tungsten electrode according to the electrode diameter being used. The
adjustable welding current is limited to the maximum permissible welding current of the
tungsten electrode.
Gas test/rinse hose package button
see "Shielding gas setting" chapter
Error/status indicators
Collective interference signal light
Water deficiency signal light (welding torch cooling)
Excess temperature signal light
safety sign signal light
NOTE
Figure 4-3
099-003133-SCO01
07.04.2014