Table of Contents
Advertisement
Important Safeguards and Warnings
The following section describes how to use this product correctly and how to prevent dangers
and property loss in using it. Before using this product, read this Manual carefully and comply
with it strictly. Keep this Manual properly after reading.
Requirements
Do not place or install the device near a heat source or where there is direct sunshine.
Do not install the device in a humid, dusty, or smoggy place.
Install the device horizontally or in a stable place. Take measures to prevent it from falling.
Do not drip or splash liquid onto the device. Make sure that the device does not bear any
objects filled with liquid to prevent liquid from flowing into the device.
Prevent foreign objects from entering the Device, which might result in damage.
Install the device in a place with good ventilation. Do not clog the air vents of the device.
Use the device only within the rated input and output range.
Do not dismantle the device without permission.
Do not transport the Device with the front panel on the bottom.
Transport, use and store the Device under the allowed humidity and temperature
conditions.
Do not expose the Device to water or excessive moisture when washing the car. Afailure
to follow this instruction might result in short circuit, fire, or other malfunctions.
The dust on the circuit board will cause short circuit, which affect the normal operation of
the Device and even damage the Device. To make the Device work stably for a long time,
please regularly use the brush to remove the dust from components, including circuit board,
connectors, and chassis.
Keep the Device installed horizontally and make sure the internal anti-vibration
components work properly.
Unlock the HDD box before pulling it out; otherwise there might cause damage to the
Device.
After all the cables are connected, tie up the cables to avoid the dangers such as short
circuit, heat and electric shock resulted from loose cables.
When a device is connected with a car mount display, mount the camera at least 2m away
from the display. If the camera and display are too close, tune down the volume of the car
mount display to avoid squeal.
Power Requirements
Use the battery exactly as prescribed; otherwise, the battery might catch fire or explode!
Always replace with the same type of batteries!
Use the wires (power cords) recommended for the region where the device is used within
the specified range of specifications!
The appliance coupler is a disconnection device. Keep a convenient angle when using it.
Advertisement
Table of Contents
