Configuring Remote Devices - CP Plus CP-RMC-D12 User Manual

Name
Time zone
System
Time
Sync PC
DST
DST type
Begin time
End time
Timing
Mode
Server
Synchronize
Port
Update
period
Step 3 Click Save.

5.3.3 Configuring Remote Devices

This section describes how to add cameras to channels. Connect the IPC to the Ethernet port
on the rear panel of the Device. You can use a holder or tie strap to fix the port.
5.3.3.1 Initializing the Remote Device
Only the initialized remote device can be added. If the remote device that you want to add has
been initialized, ignore this section.
Preconditions
Make sure the remote device supports initialization.
Steps
Description
In the Timing Mode list, if GPS or NTP is selected, configure this parameter
Configure the Time zone that the device is at
Displays the current system date and time
Click Sync PC to sync the system time with the PC from where you login the
web interface
The DST is applied in some countries or regions. Select the DST check box if it
is applied where the Device is located
1. Select the DST check box
2. According to the local regulations, configure the type, begin time and end
time for the DST
Select a timing mode, including EMSS PRO, GPS, and NTP. The default
selection is NTP
EMSS PRO: The system time syncs with EMSS PRO platform
GPS: The system time syncs with satellite
NTP: The system time syncs with NTP server that you configured
In the Timing Mode list, if NTP is selected, configure this parameter
After configuring NTP server, the Device syncs time with NTP server
1. In the Timing Mode list, select NTP to enable the NTP timing function
2. Configure parameters
Server: Enter IP address of NTP server
◇
Synchronize: Click Synchronize to sync the Device time with NTP
◇
server
Port: The system supports TCP protocol only and the default setting is
◇
123
Interval: Enter the interval that you want the Device to sync time with
◇
the NTP server. The maximum value is 65535 minutes