Installing Sim Card And Sd Card; Installing Antenna - CP Plus CP-RMC-D12 User Manual

2.3.2 Installing SIM Card and SD Card

By default, the Device is delivered without the SIM card and SD card. Install them as you need.
To connect the Device to Internet through dial-up connection, you need to purchase and
install a SIM card.
NOTE
Only supports normal SIM card.
To store recording data, you need to purchase and install an SD card.
Preconditions
Make sure the power supply is disconnected. If it is not, the Device automatically shuts down
when the door lock switch is opened.
Steps
The SIM card slot and SD card slot are inside the Device.
Step 1 Gently press the left front cover.
The left front cover automatically opens.
Step 2 Use a particular key to unlock the door.
Step 3
Loosen the two screws at the front panel and take out the HDD carrier along the guide
rail.
Positions of the SIM card slot and SD card slot are shown in Figure 2-23.
Step 4 Insert the SD card and SIM card into the card slot with corresponding marks.
In Figure 2-23, ① is the SIM card slot and ② is the SD card slot.
Place the HDD carrier back to the Device, tighten two screws and close the door lock.
Step 5

2.3.3 Installing antenna

The device antenna is installed to connect the device to the network and to locate the position
of the vehicle.
Figure 2-23 Installing SIM Card and SD Card