Network Parameters Configuration - CP Plus CP-RMC-D12 User Manual

Select PoE Reset, and click Apply to reset the camera with power but offline so that the
camera can be online. If the camera is still offline after reset for 3 times, the system will not
reset again.
When the total power of the cameras accessed through PoE exceeds the maximum power of
the device, the device will force the camera connected to the maximum port number to go
offline until the total power of the camera accessed through PoE does not exceed the maximum
power of the device.

Network Parameters Configuration

Set up the network parameters of the device as needed. This includes setting up the port, Wi-Fi
parameters, 3G/4G parameters, Email, FTP, active registration, INSTAON, and SWITCH.
Connection Setting
Configure the maximum port numbers and values.
Step 1 Select Setup > Network > Connection Setting.
The Connection Setting
Step 2 Configure the port parameters of the device. For details, see Table 5-23.
NOTE
The revised settings take effect after reboot. Proceed with caution.
Name Description
TCP
Transmission Control Protocol port, the value is 25001 by default
Port
Figure 5-49 PoE management
Table 5-23 Connection setting parameters description