Genie Z-25/8 Service Manual page 45

First Edition • Third Printing
7 Pull the cable out from under the hydraulic tank.
Do not disconnect the cable from the motor
controller.
8 Tag and disconnect the battery cables from the
hydraulic power unit.
Electrocution hazard. Contact with
electrically charged circuits could
result in death or serious injury.
Remove all rings, watches and
other jewelry.
9 Tag, disconnect and plug all of the hoses on the
function manifold. Cap the fittings on the
manifold.
Bodily injury hazard. Spraying
hydraulic oil can penetrate and
burn skin. Loosen hydraulic
connections very slowly to allow
the oil pressure to dissipate
gradually. Do not allow oil to
squirt or spray.
10 Secure the hydraulic hoses out of the way of
the component tray.
Component damage hazard.
Hoses can be damaged if they are
kinked or pinched.
11 Tag and disconnect the wiring from the power
to platform plug located on the component tray.
Pull the wiring through the squeeze connector
and the clamps.
Electrocution hazard. Contact with
electrically charged circuits could
result in death or serious injury.
Remove all rings, watches and
other jewelry.
Part No. 41314 Genie Z-20/8N & Genie Z-20/8 & Genie Z-25/8
Section 4 • Scheduled Maintenance Procedures
12 Tag and disconnect all of the wiring from the
function manifold.
13 Remove the clamps from the function manifold
and secure all wiring out of the way.
Component damage hazard.
Cables and wiring can be
damaged if they are kinked or
pinched.
14 Support the component tray with a suitable
lifting device.
15 Remove the retaining fasteners from the roller
wheel stop blocks on the component tray slide
tracks. Remove the stop blocks from the
machine.
16 Carefully slide the component tray towards the
non-steer end of the machine. Remove the
component tray from the machine.
Crushing hazard. The component
tray may fall when it is removed
from the machine if it is not
properly supported by the lifting
device.
Component damage hazard. Be
careful not to damage any wiring
or hoses while removing the
component tray.
17 Disconnect the suction hoses from the suction
strainers in the hydraulic tank at both end of the
hydraulic tank.
18 Remove the hydraulic tank from the machine.
19 Remove the suction strainers from the hydraulic
tank and clean them with a mild solvent.
TABLE D PROCEDURE
4 - 23