Genie Z-25/8 Service Manual page 46

Section 4 • Scheduled Maintenance Procedures
TABLE D PROCEDURE
20 Rinse out the inside of the tank with a mild
solvent.
21 Apply thread sealant to the threads of the
suction strainers and install them into the tank.
Z-25/8 before serial number 212
Z-20/8 before serial number 122
Z-20/8N before serial number 896:
Component damage hazard. The
hydraulic tank may become
damaged if the suction strainers
are over tightened.
All models:
22 Install the drain plug into the drain hose.
23 Install the hydraulic tank into the component
tray and connect the suction hoses from the
pumps to the hydraulic tank.
24 Install the component tray into the chassis and
install the roller wheel stop blocks.
25 Connect all the hydraulic hoses and wiring.
26 Z-25/8 before serial number 212
Z-20/8 before serial number 122
Z-20/8N before serial number 896: Fill the
tank with hydraulic oil until the fluid reaches the
mark on the outside of the tank. Do not
FULL
overfill.
Z-25/8 after serial number 211
Z-20/8 after serial number 121
Z-20/8N after serial number 895: Fill the tank
with hydraulic oil until the fluid reaches the
mark on the hydraulic oil filler cap/dipstick.
4 - 24
FULL
Genie Z-20/8N & Genie Z-20/8 & Genie Z-25/8
27 Clean up any oil that may have spilled. Properly
discard of oil.
28 Connect the battery packs and operate all
machine functions to check for leaks and
proper operation.
Hydraulic Oil Specifications
Hydraulic oil type
Hydraulic tank capacity
Hydraulic system
(including tank)
First Edition • Third Printing
Dexron equivalent
8 gallons 30.3 liters
10 gallons 37.9 liters
Part No. 41314