Genie Z-25/8 Service Manual page 42

Section 4 • Scheduled Maintenance Procedures
TABLE B PROCEDURES
4 Turn the key switch to ground controls and pull
out the Emergency Stop button to the
position.
5 Hold the function enable toggle switch to either
side and move the boom up toggle switch in the
direction.
UP
6 Inspect the filter and related components to
be sure that there are no leaks.
7 Clean up any oil that may have spilled during
the replacement procedure. Properly discard
the oil.
Z-25/8 after serial number 211
Z-20/8 after serial number 121
Z-20/8N after serial number 895:
1 Raise the boom appoximately 1 foot (0.3 m).
2 Remove the retaining fasteners from the access
panel located underneath the boom linkage.
Remove the access panel.
3 Clean the area around the oil filter housing
located on top of the tank.
4 Remove the oil filter housing cover fasteners,
then remove the cover.
5 Remove the oil filter element from the housing.
6 Clean the oil filter housing with a mild solvent.
7 Install the new oil filter element
(Genie part number 58995).
4 - 20
ON
Genie Z-20/8N & Genie Z-20/8 & Genie Z-25/8
8 Install the oil filter housing cover and tighten the
fasteners.
9 Turn the key switch to ground controls and pull
out the Emergency Stop button to the
position.
10 Hold the function enable toggle switch to either
side and move the boom up toggle switch in the
direction.
UP
11 Inspect the filter and related components to
be sure that there are no leaks.
12 Clean up any oil that may have spilled during
the replacement procedure. Properly discard
the oil.
13 Lower the boom to the stowed position.
Oil filters - Genie part numbers
Z-25/8 before serial number 212
Z-20/8 before serial number 122
Z-20/8N before serial number 896:
Z-25/8 after serial number 211
Z-20/8 after serial number 121
Z-20/8N after serial number 895:
First Edition • Third Printing
ON
44788
58995
Part No. 41314