Genie Z-25/8 Service Manual page 132

Section 7 • Repair Procedures
BOOM COMPONENTS
42 Use a soft metal drift to remove the lower boom
pivot pin. Remove the mid-pivot from the
machine.
Crushing hazard. If the overhead
crane is not properly attached, the
mid pivot could become
unbalanced and fall when it is
removed from the machine.
43 Center a lifting strap from an overhead crane
on the lower leveling arm.
44 Remove the pin retaining fasteners from the
lower leveling arm pivot pin at the chassis
pivot. Use a soft metal drift to remove the pin.
45 Remove the lower leveling arm from the
machine.
Crushing hazard. If the overhead
crane is not properly attached, the
lower leveling arm could become
unbalanced and fall when it is
removed from the machine.
46 Tag and disconnect the wires at the quick
disconnect terminals near the tilt sensor.
7 - 20 Genie Z-20/8N & Genie Z-20/8 & Genie Z-25/8
47 Tag and disconnect the wiring from the horn.
48 Remove the pin retaining fasteners from the
lower arm pivot pin through the access hole in
the chassis counterweight. Do not remove the
pin.
49 Center a lifting strap from an overhead crane to
the lower arm.
50 Use a soft metal drift to remove the lower arm
pivot pin at the chassis pivot. Remove the
lower arm from the machine.
Crushing hazard. If the overhead
crane is not properly attached, the
lower arm could become
unbalanced and fall when it is
removed from the machine.
Component damage hazard. Keep
the lower arm clear of the level
sensor during removal.
First Edition • Third Printing
Part No. 41314