Table of Contents
Advertisement
Section 7 • Repair Procedures
STEER AXLE COMPONENTS
3 Block the non-steer wheels.
4 Center a lifting jack under the front of the
chassis and raise the machine until the steer
wheels are off the ground. Place blocks under
the chassis for support.
Crushing hazard. The chassis will
fall if it is not properly supported.
5 Locate the toe-in adjustment bolt located on the
top of the motor controller side steering yoke.
6 Remove the lock nut from the adjustment bolt.
7 Pull the adjustment bolt out so it clears the set
pin and turn it clockwise or counterclockwise to
adjust the tow-in of the steer wheels.
8 Lower adjustment bolt between the selected
notch and the set pin. Install the lock nut.
9 Lower the machine and repeat step 2.
10 If further adjustment is needed, repeat steps
4 through 9.
Toe-in Specification
7 - 36
0 to 1/4 inch
(0 to 6.4 mm)
Genie Z-20/8N & Genie Z-20/8 & Genie Z-25/8
First Edition • Third Printing
Part No. 41314
Advertisement
Table of Contents
