Table of Contents
Advertisement
1256E User Manual
Saving/Recalling the
Verification Masks
Automatically
Recalling
Verification Masks
at Startup
Racal Instruments © 2002
As was the case earlier, channel 11 is excluded by the mask and
will not show up in the error report. In addition, the 1256 will show
only the first ten failures it finds when a large number of channels
are specified in a query.
These commands are NOT defined in the SCPI standard. These
commands follow the syntax rules of SCPI to implement this
functionality.
All verification masks presently defined may be prepared for
storage
in
non-volatile
command.
All module names stored in non-volatile memory may be recalled
from non-volatile memory using the VERIFY:RECALL command.
The syntax for these commands is shown below:
[ROUTe]
:VERify
These commands are NOT defined in the SCPI standard. These
commands follow the syntax rules of SCPI to implement this
functionality.
The actual process of updating non-volatile memory
requires a separate SYSTEM:NVUPD command. This
allows multiple relay states, exclude lists, include
lists, and module names to be updated in rapid
succession, followed by a single, slower update of
the actual non-volatile memory.
In addition to defining verification masks, the user has the ability to
determine whether the masks stored in non-volatile memory are
recalled on application of power to the system. The command
syntax is as follows:
[ROUTe]
:VERify
memory
using
:SAVe
:RECall
NOTE
Advanced SCPI Operations 8-21
the
VERIFY:SAVE
Advertisement
Table of Contents
