Removing Module Names; Reading The Presently Defined Module Names - Racal Instruments 1256E Manual

Removing Module
Names
Reading the
Presently Defined
Module Names
SCPI Command Basics 5-32
Close Power relay channels 7 through 12:
CLOSE (@Power(7:12))
Closes relays on two modules:
CLOSE (@Power(8),matrix(102:104))
The MODULE:DELETE command may be used to delete a single
plug-in module name from the list of known module names. The
MODULE:DELETE:ALL command may be used to remove all
presently defined module names.
The syntax for these commands is:
[:ROUTe]
:MODule
:DELete <module name>
The following examples illustrate the use of this command.
Removes the name "scanner":
ROUTE:MODULE:DELETE scanner
Removes the name "matrix":
MOD:DEL matrix
Remove all names:
MOD:DEL:ALL
The MODULE:CATALOG? command may be used to read back all
of the presently defined module names. The format for this
command is:
[:ROUTe]
:MODule
The reply to this command consists of the presently defined
module names, separated by a comma. Module names are stored
internally in upper-case characters by the 1256. These upper-case
names are returned in the reply.
:ALL
:CATalog?
Racal Instruments © 2002
1256E User Manual