Table of Contents
Advertisement
Computer Interfaces 4-4
with:
-----SETTINGS-----
>
Type: Display
Option: Format
Status: Decimal
3. Select the remote interface settings mode by rotating the knob
until line 2 reads as shown below (lines 3 and 4 may differ):
-----SETTINGS-----
>
Type: Remote
Option: Lockout
Status: Disabled
4. Press the third key to select line 3 of the display. Rotate the
knob until line 3 indicates the "Source" option as shown below:
-----SETTINGS-----
Type: Remote
> Option: Source
Status: GPIB
5. If line 4 of the display already indicates the status as "TCP/IP",
then the GPIB interface is already active; no further action is
necessary. Otherwise, press the fourth key. Rotate the knob
until line 4 indicates "TCP/IP":
-----SETTINGS-----
Type: Remote
Option: Source
<Update?: TCP/IP
Then press the fourth key to confirm the update. Pressing any
other button cancels the change.
Menu preferences are not normally retained after the
power is removed from the instrument. To make (a)
menu preference(s) permanent, make the desired
change(s) to settings first and then proceed to the
section Storing the Menu Preferences to make the
changes permanent. Following this procedure will put
the settings into non-volatile memory and allow them
to be restored during instrument power-up.
1256E User Manual
<
<
<
NOTE
Racal Instruments © 2002
Advertisement
Table of Contents
