Extron electronics Cable Cubby 300C User Manual page 22

2. If the Phillips head screws on the front and rear of the cubby are blocked by the table,
remove the cubby from the table (see
steps 1 through 4, on page 12).
3. Before you add an additional power module, you must make room for the Cable Cubby
by eliminating two or three AAP spaces and the AAP shelf brackets that support them.
Remove the Phillips head screws on the front and rear of the Cable Cubby and gently
push the assembly(ies) out through the bottom of the cubby.
4. From the underside of the Cable Cubby, gently push the additional power module into
the desired position at the desired elevation. Secure the power module into position
with the four included Phillips head screws (see figure 16).
ATTENTION: Potential damage to property. To ensure good electrical
grounding, use the star washers with the screws.
Extron
Cable Cubby 600
2 Screws ea. side
Figure 16. Installing the Power Module
5. If desired, assemble and install replacement AAP shelf assemblies. Remember that
the cable pull function of the Cable Cubby requires at least a two-space AAP (see
"Installing the Cables and
6. If you removed the cubby from the table, reinstall the enclosure (see
Replacing the Cable
Cable Cubby 300/600/800 • Maintenance and Modifications
Get other manuals https://www.bkmanuals.com
"Removing and Replacing the Cable
AAPs" on page 7).
Cubby" steps 7 through 10, on page 13).
Cubby,"
"Removing and
17