I/O Signal When Cc-Link Ver.2 Double Setting Is Selected (Pr.544 = 12) - Mitsubishi Electric FR-A8NC Instruction Manual

6.2.3

I/O signal when CC-Link Ver.2 double setting is selected (Pr.544 = 12)

 Remote I/O (32 points)
Same as when Pr.544 = 0 (Refer to
 Remote register
*2
Address
Upper 8 bits
RWwn Monitor code 2
Set frequency (0.01 Hz increments) /
RWwn+1
torque command
Link parameter
RWwn+2
extended setting
RWwn+3 Write data
RWwn+4 Monitor code 3
RWwn+5 Monitor code 4
RWwn+6 Monitor code 5
RWwn+7 Monitor code 6
*1 For the FR-A800 series, when Pr.804="3 or 5" during torque control under Real sensorless vector control or vector control, a torque
command value is set in RWwn+1.
*2 "n" indicates a value determined according to the station number setting.
58
I/O SIGNAL LIST
page 54)
Description
Lower 8 bits
Monitor code 1
*1
Instruction code
Refer
*2
to
Address
page
RWrn First monitor value
RWrn+1 Second monitor value
RWrn+2 Reply code 2
68
RWrn+3 Read data
RWrn+4 Third monitor value
RWrn+5 Fourth monitor value
RWrn+6 Fifth monitor value
RWrn+7 Sixth monitor value
Description
Upper 8 bits Lower 8 bits
Reply code 1
Refer
to
page
71